1.0 Solder a fuse holder on PCB board instead of soldering fuse directly on
the board.
2.0 Then place your 2A fuse into the fuse holder, switch on the power.
3.0 If the fuse blow, then replace another fuse while the power switch is
off. Then you switch on the power.

If the fuse is blow again, kindly repeat 3.0.

If you have repeated the step 3.0 for more than 10 times, perhaps you can
email me, I will sell you the fuse at dealer price, a packet of 50 units
fuse will cost you RM 15.00. Then you can repeat the step 3.0 procedure.

"Seventh Prince" wrote in message
oups.com...
Hi,

Any advise for How to solder live 2A glass fuse to Power supply board
in exchange for the pcb solder 2A fuse. And what type of power wire
should be used to connect the glass fuse to the PSU board? I need to
solder the wire to the glass fuse in order for further soldering to the
PSU board.

Have tried with thin insulated signal wire and ceramic fuse wire but
PSU will blow out fuse each time. AC voltage is 240V.

Thanks.