On Sun, 21 Aug 2005 19:46:29 -0600, "mywebaccts (at) PLUGcomcast.net"
"mywebaccts (at) PLUGcomcast.net" wrote:

I figure I can do both. Apparently, one can spend a LOT on a miter
gauge. It seems to make sense not to chince out in this area, but
spending over a hundred bucks just for the miter gauge seems a bit too
much for me.

Does anyone have any suggestions or recommendations regarding miter
gauges for a home-built router table?

Depending on your budget there are always used original equipment
gauges on Ebay pretty cheap. Another thought is the low end Incra v27
which can be had for about $55 at woodpeck.com. Even though the Incra
has it's limitations, I think it's still better than most original
equipment gauges.

Mike O.