"R and L Catherwood" wrote in message
...
Hi,all,
my husband passed away a few months ago,and now I have joined the world of
"home repair"...well.... kind of.
Can anyone assist me in placing the burner ,with the venturi ,back into
place in my Kenmore propane barbeque.

I noticed that one side section of the burner was not working properly...I
had both sides on "high",but the flame on the right side was very low.
Maybe something was plugged....!!!????

Later,when everything cooled,I removed all the grills,and lava,AND the
burner to clean,and when I tried to replace the burner,I could not get
the
venturi tubes placed correctly over the orifices...is there a trick?

I went to the manual,but it showed connecting the venturi BEFORE the
plate,and knobs were installed...do I have to remove the plate, and the
knobs again?...I tried the knobs, and it feels like I will need a crowbar
to
remove them.
Any suggestions are appreciated.

The barbeque has lots of years left
Thanks,Rose



I can't help with the replacement of the part, but: Believe it or not, there
are spiders that will set up home in the burner tubes. Stores with a good
selection of cleaning accessories sell a skinny brush specifically for
clearing the tubes.