I'm having a hard time visualizing a 3/4" MT2 collet. The nose on the MT2
collets for my Clausing 8520 mill are ~ 0.71" OD, so clearly a 3/4" collet
is not possible in that exact form factor. What am I missing?

"Peter Wiley" wrote in message
. ..

I have 5/8" and 3/4" MT2 collets. The dia doesn't go right thru the
collet body, obviously, but they do exist.

And yes, I do know the difference between a collet & an end mill holder.

To the OP, go buy a collet chuck with a MT2 shank, using ER32 collets.
Lot less hassle than swapping collets all the time.

PDW

In article , Mike Henry
wrote:

I'm pretty sure that MT2 collets max out at 1/2". Much bigger and the
entire collet will be taken up with the collet bore. Were you perhaps
thinking of end mill holders?

"himog" wrote in message
oups.com...
All right, where can I get more like these, such as the 5/8 and 3/4 in
the picture? It seems obvious that these inexpensive collets are being
made in more sizes. Where can I get them individually or in more
comprehensive sets?