thanks, guys. sorry its a Kenmore model 11087870100 22000 btu/h i
got 120v to the gas valves. the ignitor does not glow however when
i shorted across the sensor (flame) the ignitor glowed but the gas
valve didnt open. should the gas valve open when the sensor "sees"
the glow from the ignitor? or does the sensor switch need to open
after it sees the glow ( to allow the gas to come on)?? at this
point i'd think its the flame sensor.....what u think? thanks


On Wed, 27 Jul 2005 09:55:19 -0700, ~^Johnny^~
wrote:

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 27 Jul 2005 04:31:08 -0700, "Appliance Repair Aid"
wrote:

Still leaves....motor heat switch, timer, temp selector switch ( if
used ), operating thermostat(s), safety thermostat(s).


unless his igniter is cycling (getting current)

but he didn't say


-----BEGIN PGP SIGNATURE-----
Version: PGP 7.1

iQA/AwUBQue8cQIk7T39FC4ZEQLtIACdGn5uGqmoGXqo2jYDRuXQi0 Gps/gAoLr+
+n/JyhJB7TeDXLg8OHdASFaY
=WDxI
-----END PGP SIGNATURE-----