Is it really necessary to grind the table perfectly flat before tackling the
mag chuck?

I also have a KO Lee grinder (S714) and have only been planning to dress the
top surface of the chuck. Gotta resolve a scalloping problem first, though,
and that's long overdue.

BTW, can you convert "quick" longitudinal feed rate to something like inches
per minute, at least roughly? I've been half-heartedly trying to get a
handle on what sort of feed rate should be used.

Mike

wrote in message
ups.com...
I don't have a typical grinding job, but since I am grinding the
surface grinder table I want it to be as close to specifications as
possible. Following the table I will grind the magnet. Anything I
grind after these two pieces will never be more accurate than the
variance I obtain on them.