-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Tue, 19 Jul 2005 15:56:38 -0400, "Eric Kort"
wrote:

In replacing the wig-wag/solenoid unit on my Whirlpool belt drive
washing machine, I inadvertently tore the wires off the two
solenoids before labeling them. The wires are undamaged, and I was
able to replace the unit, but now I am unsure which wire goes
where. There is a red wire which I believe is for the spin cycle
solenoid, a yellow wire which I believe is for the spin cycle
solenoid, and two white wires which I presume are ground. But I am
not completely sure that is right, and I am not sure if it matters
which contact on each solenoid is load vs. ground.

Can someone tell me which wire goes where?

Thank you,
Eric


http://www.thisoldappliance.com/wigwag.html




-----BEGIN PGP SIGNATURE-----
Version: PGP 7.1

iQA/AwUBQuFbZwIk7T39FC4ZEQITwgCZAWENjQfuJxmVotEoiRRNPq RqccoAoKMS
XUyWy0zi2fCxytcM69CCokwA
=Dv5y
-----END PGP SIGNATURE-----

--
-john
wide-open at throttle dot info