On Tue, 19 Jul 2005 08:25:17 -0700, wrote:

Hi can anyone help

I have a worcester 9 - 24 heatslave combi boiler.
I have just replaced the pump and diverter valve.
The CH heating is working fine but I can't get any hot water.
When I turn on the hot water tap the flow is very low i.e not at
mains pressure as it should be.
Anyone got any ideas?

One hot tap or all hot taps?
How is the cold water flow/pressure?

Did you turn the cold feed to the boiler back on again - fully?

Has dirt collected on an inlet strainer?

--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at http://www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html