On Wed, 29 Jun 2005 14:39:58 +0000 (UTC), Dave
wrote:


Thanks Andy.
How easy was it to get the jig in the right place?

Very - most of them locate with pegs

I was assuming it
would come with screw holes so it could be screwed to the underside of
the worktops; clamps must be a pita.

You could make holes for screwing down, but obviously not if you rent
the jig. I already hae a bunch of clamps anyway for woodworking but
three or so cheap G clamps or similar would be fine.



Anybody any suggestions on how to guarantee that the joint is sealed?

Silicone sealer in the joint




anybody got a jig to flog?

Dave


--

..andy

To email, substitute .nospam with .gl

The information contained in this post is copyright the
poster, and specifically may not be published in, or used by
http://www.diybanter.com