Greg Jensen wrote:
Why not just take a hack saw and cut 1/2" off the end of the spindle. Then
file it smooth.
Rather than do anything that can't be undone, try turning a small HARD
wood disk and drill out the center. When it wears out, make a new one.
If you turn it the sides WILL be parallel.
Dave in Fairfax
--
reply-to doesn't work
use:
daveldr at att dot net
American Association of Woodturners
http://www.woodturner.org
Capital Area Woodturners
http://www.capwoodturners.org/
PATINA
http://www.patinatools.org