"James Nyman" wrote in message
news:i3Qre.6289$fa3.2335@trndny01...
I have had several coffee makers burn out due to the microtemp. Is this
because they put under-rated ones in order to sell more coffee makers? I
wonder if it would be safe to replace it with one with a little higher
temp.
rating? Any one have any experience with this problem? Also I am sure you
can't solder the new one in, but would a crimping type connector work?

Thanks, Jim = nyman at verizon.net



It's not that the protector is too low, it's that the coffee makers run too
hot. Are they thermostatically controlled?