Upgrading GCH to sealed system - Expansion Vessel Question
On Mon, 10 May 2004 13:16:59 +0000 (UTC), "MIKE THORNE"
wrote:
"Andy Hall" wrote in message
.. .
On Sun, 9 May 2004 22:14:42 +0100, "John Stumbles"
wrote:
"Vortex" wrote in message
...
Actually I was thinking of the Fernox Gel so the capacity is a non
issue
really.
Cheaper to buy a cheap pump-spray (Hozelok garden sprayer type) and
bog-standard liquid Fernox and use the sprayer to squirt the liguid in
through the filling loop connection point (with suitable adaptation to
sprayer to get it to 15mm or 1/2" BSP)
My patented adaptation to do that is:
- Cut aluminium tube of sprayer lance.
- This fits an 8mm compression fitting.
- Short length of 8mm copper tube for other side of fitting
- 8mm solder female x 15mm male adaptor
- 15mm compression service valve with nut and olive on one side
discarded. A male to male compression coupler would do, but I had a
discarded service valve.
- Connect filling loop braided hose to above
- Pump away. (as it were).
.andy
To email, substitute .nospam with .gl
Fernox do a filler kit, Wolseley centre catalogue number 603120. at £44 it
could sound expensive but if you are using cleanser and inhib every 3 years
it cuts down on the hassle. It comes with 2 rad vent adaptors (useless) but
the hose adapts to a filling loop hose quite readily with a 15 mail iron and
a 10mm insert.
True.... but in reality, all it is is a garden type sprayer with some
bits which with the above shopping list I can make in about 5 minutes
for £15.
..andy
To email, substitute .nospam with .gl
|