On Thu, 26 May 2005 02:15:35 GMT, the inscrutable Ken Sterling (Ken
Sterling) spake:

Gang,
If you care to, take a look at a modification I did to a zero-turn
riding mower front end caster setup. The original (I think) was a bad
design and I couldn't think of an easy fix. Picture *have* been
renamed THIS time G and I decreased the size of the files for
faster downloading..... hope I did it all right.
Thanks for looking - and any and all comments appreciated.

Very nicely done. Some cleanup and paint prior to the last picture
would have done you service, though.


Find them at:
http://www.metalworking.com/DropBox/caster0.txt
http://www.metalworking.com/DropBox/caster1.jpg
http://www.metalworking.com/DropBox/caster2.jpg
http://www.metalworking.com/DropBox/caster3.jpg
http://www.metalworking.com/DropBox/caster4.jpg
http://www.metalworking.com/DropBox/caster5.jpg
http://www.metalworking.com/DropBox/caster6.jpg
http://www.metalworking.com/DropBox/caster7.jpg
http://www.metalworking.com/DropBox/caster8.jpg


--
REMEMBER: First you pillage, then you burn.
---
http://diversify.com Full Service Website Development