In article . com,
wrote:
All,

I am new to the dovetailing game and I need some advice. I recently was
given a Leigh D4 as a graduation gift and am attempting to make some
boxes. The boxes will have 4 sides only (i.e. no bottom or top) and
will be used as modular storage in my new apartment. I will be using
through dovetails to join them.

According to the Leigh manual, the maximum thickness of the pin board
is 1" but the stock I have is 5/4". What dovetail/straight bit
combination do I need to join these thick pieces? I'd rather not plane
it down as I like the look of the very thick walls.

Thanks,
Ben


I am not familiar with using the Leigh jig, but would it be possible
to rabbet the pin board to 1" at the pins and cut the tailboard to
match?


--

Larry Wasserman Baltimore, Maryland