Hi Rik!

I'm not that familiar with this model but what you describe sounds much more like trouble in the horizontal. If you got a vertical stripe there is no horizontal deflection.
Follow the wiring from the deflection yoke on the crt neck down to the board and check components in the area were the wiring enter the board. If you are lucky it's only a cold solder joint otherwise i belive that there isn't many components which could cause this problem.

Björn
"bwana" skrev i meddelandet ...
I have a akai tv witch goes to standby mode when switched on, two daches displayed on led display.
When you switch the set on several times you can see only a vertical stripe ( no vertical deflection) but goes always to standby.
When i disconnect the 5.1 voltage from ic 760 the system starts up with only the vertical stripe and no led display and no sound.
replaced ic01 msp2400 with no result.

thanks in advance

Rik