"Andy Hall" wrote in message
...
On Tue, 4 May 2004 15:46:24 +0100, "IMM" wrote:

Well time to fill up. I always fill with just fresh water in case of a
swift drains down in case of a problems and lose the inhibitor.
Lo-and-behold one Speedfit fitting was ****ing out. A swift drain down.
On
inspection the O ring had been pushed out of its housing ring and was
bunched up further down the fitting. The pipe inserted was plastic that
pushed the O ring put.

What did you use to cut the pipe

A hacksaw and trimmed it off with Stanley knife to remove an burred edges.
The insert butted right up against the pipe. The insert was not the
problem, the problem was the poor fittings...fittings made by an ex toy
maker. The toy box is the best place for them.