On 29 Apr 2005 05:16:30 -0700, wrote:

Well, I got the u joint in but two apposing cups dont seem to be in the
bore far enough below the grove the spring holders go in. Although I am
not sure. I will say when I twist it there is abolutely no give in the
joint like would be evidenced with a bad u joint.

If new parts won't seat and they are the correct ones you most
likely have a needle between the cross and cup. It's a bit tricky to
get both cups aligned without loosing a needle the first time or two.
Three hands are best :') Are you using a vise or a press?
Extra grease will help hold the needles in place while assembly.
Take it apart and reassemble, don't run it without the clips in place.
Sometimes the yokes get bent when knocking out the old joint,
if so you need to resize things. Measure over the new cups and
check the snapring grove measurement.



One other thing I found is after about 3 full squirts of grease grease
started coming out from under the little rubber seals at the end of
some of the caps. is this normal?

The grease has to go somewhere.

DE


----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----