Thread
:
Slicking Up the TS Table (and a bit of gloat)
View Single Post
#
2
Patriarch
Posts: n/a
wrote in news:rng861d089heok4acqjlkkg97ihv2o40ck@
4ax.com:
snip
Is that table slick? Being a guy who wonders if time is well spent, I
ran a test as I went.
Test Conditions
6" rule held vertically at edge of table. 10" steel rule from top of
6" rule, slanting to table. Actually it's a 12" rule, but I put the
10" mark on top of the vertical 6" rule (30 degree slope if I remember
the 3,4,5 triangle correctly). Sled was a 4" long hunk of maple 1X2,
square at the leading end, unsanded on the bottom (not prepped in any
way).
You made a table saw Stimpmeter?
Reply With Quote