Thanks for the part #'s. Had forgotten about Mc Master. I think
stainless may be too hard as I need a 7mm rod in order to drive a
slug down my barrel to make a throat slug without hurting the bore..
Cold roll will not hurt the bore but don't know about the others.
Thanks again, Kent

On Fri, 01 Apr 2005 21:59:36 GMT, "Joe AutoDrill"
wrote:

Was wondering if anyone had a source for 7mm cold rolled rod. Tried
the usual, MSC, Enco, J and L, Small parts. but couldnt come up with
anything. Thanks, Kent

McMaster. Some may be stainless... Hope this helps!

8116K36 but it's not really CRS, it's drill rod... 6' = $21.88

88695K21 (.277") 3' = $4.45

88625K66 3' = $3.15

88755K51 (.277") 3' = $3.43

1274T17 1 meter = $17.96 - Stainless

1272T16 1 meter = $15.08 - Stainless


Regards,
Joe Agro, Jr.
(800) 871-5022
http://www.AutoDrill.com
http://www.Multi-Drill.com