Doug Miller wrote:
In article , zxcvbob wrote:
Doug Miller wrote:
In article , "Edwin
Pawlowski" wrote:
"toller" wrote in message
...
Home Depot (and presumably most other places, though I haven't tried) will
cut and thread iron pipe for free. Presumably they would do the same for
a brass nipple.
Or is there something that is going clean over my head?
Some pipe threaders will not allow a short length to be held in the jaws and
threaded. There are ways of doing it, but I have no idea of HD will have
the capability. No harm in asking though.
He could buy a longer piece (e.g. 12") and have it threaded for, say, 5
inches
at one end, then cut off what he needs.
IIRC, he needs it threaded at both ends.
And your point would be....?
I believe he only needed about three inches, right? So thread *five* inches,
and cut off the three-and-whatever that's needed. No harm done if it's
threaded all the way, is there?
Tapered threads.
Bob
|