"J.B. Bobbitt" wrote in message
m...
I appreciate the insight.

No, I'm not sure. The piece I cut out has no identifying or
distinguishing
markings, and it looks like regular drywall. This patch is above the
pre-fab shower enclosure, but the brass threaded elbow for the shower
fixture sits behind drywall about 8" above the lip of the enclosure.

The other thing I don;t like about this arrangement is that the bottom
edge
of the drywall sits on the lip of the pre-fab enclosure all along the top
of
the enclosure, and the caulk seal deteriorates and looks ragged.

I'm starting to think the builder didn't do this quite right.


What else would you suggest doing, putting the lip on top of the drywall?
Your arrangement is standard procedure and is usually done with green board,
that is, water resistant drywall. That is what I did with a shower and a
bath tub 15 years ago. Still no problems.

--
Mike D.

www.stopassaultnow.net

Remove .spamnot to respond by email


-jbb


"Joseph Meehan" wrote in message
...
J.B. Bobbitt wrote:
The surface will be painted w/ gloss enamel paint.

-jbb

That is nice, but not what I would consider real protection. Regular
drywall does not do will in damp conditions. They make a special
product
for those situations. Are you sure it is standard drywall?


"Joseph Meehan" wrote in message
...
J.B. Bobbitt wrote:
I had a small shower fixture leak behind drywall. I've cut out the
bad drywall and repaired the leak, and now I'm replacing the drywall
patch (~8" X 12").

I've used a hole saw to cut the hole for the shower head fixture.
The hole will only be covered with a small flange. I don't like the
idea of the raw drywall edge being exposed to the moist environment.

Is there a preferred sealant or method for raw drywall edges?

Thanks a heap,
-jbb

If it is drywall the surface is just as much of a problem as the
edges. --
Joseph Meehan

26 + 6 = 1 It's Irish Math

--
Joseph Meehan

26 + 6 = 1 It's Irish Math