That was my point exactly, when the device trips, you want it to be the
outlet you're standing in front of and not the one in another room. I do
recommend pigtailing the wires under a wire nut rather than depending on the
clamp screws of the receptacle, this way, if you have a loose connection on
the outlet, it only affects that outlet and nothing downstream
"Jag Man" wrote in message
m...
The instruction sheet that comes with the Leviton GFCI receptical
shows
downstream loads daisy-chained off the Load connection points on the
back.
There is also provision for an extra connection off the Line
connection point
on the device. I believe using the latter is equivalent to what you
call
pigtailing. I called Leviton tech support and was told that one can do
both.
I did this when I wanted two bathroom outlets, both GF protected. I
did
not want all the outlets daisychained off the existing bathroom outlet
to
be riding off the bathroom GFCI because a trip would be hard to trace.
So, I tapped off the Load points for the second bathroom outlet, and
off the Line point for reconnecting the existing downstream outlets.

That said, I'm not an electrician, so take this for what it's
worth....

Ed


"RBM" rmottola1(remove wrote in message
...
As electrical codes changed, electricians found clever ways to meet
them and
save money. In your case, If your shower caused the thing to trip,
you have
to run down into the garage to reset it. Not very practical. The
early
models did false trip often. I'd recommend changing all the outlets
in the
affected areas with new Gucci's. Just be sure to pigtail your wires,
so
you're not running loads off of the downstream terminals of the
receptacles