Mebbe you can turn that member upside down, and perform the same operation
to straighten it out. Might have to weld a provisional doo-dad or two.
Or take to someone w/ a hydraulic press or a big-assed arbor press.
----------------------------
Mr. P.V.'d
formerly Droll Troll
"Richard J Kinch" wrote in message
. ..
Bart D. Hull writes:

Two friends have already had the HF /import lifts destroy the ram and
drop the load.

I was using mine (in the "1000 lbs" position) to pull up on some small
palm
tree stumps to uproot them. I must have overloaded it because the inside
and outside tubes of the telescoping lifting arm are both bent slightly
now, and I can't stow it all the way in. So it would appear that the
hydraulic ram does not bypass before bending the tool structure itself.

Not sure how I can straighten it, either. Bother.