In article , george@least says...


OK, I'll bite. How far out do they have to be to exceed the adjustment
capability of the jig? You _have_ read the manual on how to compensate for
individual bits? The Leigh people recognize the reality that bits are
different even within the _same_ manufacturer's line.

Bite away George, but don't choke on it. I've read the instructions,
have you_ever_used the jig? How does the adjustment capability of the
jig affect the fit of half blind dovetails? A hint, it doesn't. The
angle of the bit does however, but if you had read the instructions you
would know that. I don't know if the bit I tried was undersized, or the
wrong angle, and I don't care. The bit did a very poor job for me. Like
it or not, that is my opinion.

Zeke

change com to net for e-mail