"Rick Brandt" wrote in message
...
"Fred Mann" wrote in message
...

The part with the suction-cup-looking thing? Which spot is the wrong
spot?
(tantalizing) If I can do this without dying, I'm game.

Well there could be several, but the suction cup looking thing is
definitely one
of them. Just be careful in getting the board set up where you have
access to
the solder joints and then avoid touching any circuit that you don't have
to.


THANKS!! Where would the other flyback be?



The flyback is a notorious area for developing bad solder joints. Often
you can
even see discoloration where the circuit was arcing so see if you can find
any
of those. It is also not unusual for these failures to be internal to the
flyback so many times you can resolder the whole board and it doesn't
help.