Dr. Deb wrote:

I have a Jet 1442, which I dearly love (my fourth lathe and glad of the
other stops along the way - made me appreciate this one more), with a
Reeves drive. My problem is when I use the highest two speeds the lever
gets in the way when I try to turn near the headstock. I would assume this
is because of an error in my turning technique. But when I am cutting a
bowl and putting the finishing touches on the bottom I have to work around
the lever. Yesterday, I was tuning some bobbins for my daughter's spinning
wheel and found the lever in the way when using the skew to clean up the
center portion of the bobbin.

Any hints?

Thanks

Deb
How is the lever mounted on the shaft? Can you reinstall it
at a different angle?

--
Gerald Ross
Cochran, GA

Know what I hate? I hate rhetorical
questions!





----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----