"No" wrote in message ...
If you notice that your ice making had decreased in the same period that the
noise started you might check to see if some ice is stuck and causing the
plastic arms to stick. That happened to mine a few times, water spills over
and ice forms and when the prongs that pop the ice cubes out got to rotate
they can't because the ice has them stuck, this can make it creek...

If you are making ice as much as you always has it may be something else....
but it's worth checking it out.


This is Turtle.

The Creeking noise that you speak about is the plastic gears slipping when
waiting for the mold heater element to make the ice cubes turn loose and also
make the creeking noise when the fingers are hung up in anyway, too. If the
gears are real good and not worm any at all. the gears will not slip and make
the creeking noise. Now when they start creeking while normal operation the
gears are getting worm down and will in the future bite the dirt when they break
a tooth or two.

The O.P. did say it was still making ice so being stuck long term was not the
case. Now it could have spell where it would start and then stop hanging up with
ice holding the teeth.

I really don't know because I can't see it from here and he has that Ford
Station Wagon parked in the way.

TURTLE