"Leon" wrote in message
om...

"Mr Fixit eh" wrote in message
oups.com...

Snip


I'v run cuts without the crosscut sled and there is no signs of
burning. With the crosscut sled--burn marks.


When you cut WITH the cross cut sled are you feeding the wood from the
same side of the blade as when NOT using the cross cut sled? Some times
miter slots are not parallel. Does your sled use the same miter slot that
you used to tune the TS?

....and are you sure the sled is precisely aligned? If the marks are always
on the same side you may not have an exact 90-degree angle on the sled.

Bob