"diverse_guy" wrote in message
...

I guess I need to decide on getting the:
1023SL which is 3HP Left tilt $995
1023Z which is 3HP $1050
or throwing out an extra $100 for the 1023ZX which is a 5Hp and cost
$1150

Get 5 hp if you will be power feeding all day long every day. Other wise
3hp is almpost over kill. I use 3hp to resaw 5" wide Ipe boards awith no
sign of the saw straining. Ipe is 3 times harder than Oak.

I've read that left tilt is best. is this always true?

;~) The single most asked question in this group that I paste this rubber
stamp answer to.

Both saws will make all the same cuts. Some easier on the left tilt, some
easier on the right tilt. Strictly personal preference. But if you need to
be steered one way or the other,

Advantages:

Are you right handed?

Get the left tilt.

1. Left tilt has the bevel wheel on the right side and is easily turned with
your Right hand.

2. Left tilt can rip a narrow bevel with out having to move the fence to the
left side of the blade.

3. Left tilt allows the blade arbor nut to be removed with your right hand.

4. Left tilt allows your to remove the arbor nut and turn it in the
direction that you would expect.

5. With a Left tilt, when both edges of a board are beveled, the sharp point
of the
bevel is up on the fence when cutting the second bevel as opposed to the
bottom of the fence where it might slip under.

6. RIGHT tilt if you are left handed. The bevel wheel is on the left side of
the saw.

7. RIGHT tilt if you "must" use the fence distance indicator when using a
stacked dado blade set. The blades stack left, away from the fence. The
indicator remains accurate. On the left tilt, the blades stack towards the
fence and makes the indicator inaccurate. In this case use a tape measure to
set the fence distance.

8. RIGHT tilt allows you to remove the arbor nut with your left hand but the
nut must be turned clockwise to loosen. Bassackwards to normalcy.

If considering a cabinet saw, with wide 50" rip capacity.

The Left tilt will most often afford you the most storage room under the
right table extension. The RIGHT tilt has an access door in that location
that will demand room to open. The left tilt allows you to have access to
the motor and or the insides of the cabinet from the more open left side of
the saw with out having to crawl under the right extension table. Very nice
if you ever happen to drop the arbor nut inside the cabinet. If you are
considering getting a replacement saw and considering going to the opposite
tilt this time consider that the miter slots may not be the same distance
from the blade when comparing a left to right tilt saw. This may or may not
be of concern but something to consider.