"AZGuy" wrote in message
...
On Sun, 16 Jan 2005 11:31:23 -0500, "Ross Mac"
wrote:


"toller" wrote in message
...
I have a Kenmore 106.515541004. It is the same as the Whirlpool
ED5SHAXMT; the one with ice in the door. It is now 3 years old.

Last April I went on vacation and turned the water off. When I turned
it
back on, the ice maker didn't work. About a week later it started up
again and ran for a few weeks before it died. After a week it ran fine
for 9 months. Now it is dead again.

Any advice? I don't use ice, but she does.


Ice makers aren't my specialty but you might have a stuck solenoid. Do
have
anyway of telling if water is getting into the unit? Also, there should be
a
switch to tell the icemaker it is full (so to speak) and it may be
sticking
or flaky. You might excercise the switch and see if that helps.....good
luck,Ross



It's also not uncommon for the water inside the nozzle that feeds the
ice tray to freeze. When that happens you can't make ice even though
everything else is working correctly.
--
Elbridge Gerry, of Massachusetts:

"What, sir, is the use of militia? It is to prevent the
establishment of a standing army, the bane of liberty. . .
Whenever Government means to invade the rights and liberties of
the people, they always attempt to destroy the militia, in order
to raise a standing army upon its ruins." -- Debate, U.S. House
of Representatives, August 17, 1789

That is a good point....does the OP have a way to measure the temperature of
the freezer compartment? It should be about zero degrees with the fridge
compartment about 38 degrees.....good luck, Ross