On 11 Jan 2005 13:41:37 -0800, "Sexytom976"
wrote:

The use of PVC inside walls is basically illegal.

Either it is, or it isn't, "basicly" is not a real qualifier.

So I went looking for PVC, couldn't find it in the US's 2002NEC; so,
I'm guessing you mean RNC(Rigid Nonmetalic Conduit Article 352).
Section 352.10(A), RNC is permited to be conceiled in walls, floors,
and ceilings. So per the NEC, it is ok to stick inside walls.

You are NOT suppose to use it inside for 2 reasons.
1 is that wires can get hot, hot wires inside a plastic

The most conductor insulations are plastic.

conduit sounds like a good way to kill yourself
from fumes if there is a fire (caused by electric)

If there is a fire, generally there is smoke.


Its only used OUTSIDE and underground. (PVC = No Rust)

Metal conduit would just be too much of pain in the ass
for in walls installation. Romex would be the cheapest route
but just remember to follow romex guidelines. (it can
be left exposed ONLY on the ceiling)

Couldn't find romex guidlines in the NEC, did find nonmetalic
sheath(NM) cable. Only under certain conditions, like locations:
UNfinished basements, and attics. Sec. 334.15, and special
precautions need to be followed,


BX cable might be a better choice for you. Its a pain to
work with (actually I prefer it to romex) but it shielded
and can be run just about anywhere.

If you are enclosing the walls, I would stick with NM, and properly
follow the code. If not, then move up to Metal Clad(MC), I just feel
safer knowing I have an actual grounding conductor. Yeah, I know the
cable jacket becomes grounded with proper installation, but having
that seperate conductor will help you sleep better at night.


If you decide to use conduit, just remember that you are
NOT suppose to run romex or bx THROUGH conduit. This IS
against the NEC code! (also a waste of space)

I agree with waste, but mostly money. As for running cable, I know
everyone say don't do it, but it's debate on why? Personally the
increased costs and double jacketing it, is a turn-off, but where in
the code does it say you can't? Thank you.

You run single wires through it. (thats why PVC is NOT good
for inside work)

Tom


PVR wrote:
I am finishing my basement. This will include some wiring. Are the
three
kinds of conduit (PVC, standard metal and thin metal) considered to
be
interchangeable? I am using 2" foamboard onto poured concrete covered
by
1/2" drywall. The conduit will be attached to the concrete before the
foamboard is installed.

Peter.

Hi Peter, if you can't maintain a 1-1/4" seperation from the outside
edge of the studs and your cable, you will need to come up with
protecting the runs. If you go with thicker walls, like with 2x4's,
you should have no problem with finishing the basement wiring like
normal house wiring.

btw, always only allow qualified personnel to only do work on your
house.

hth,

tom @ www.URLBee.com