Check the solder connections under the relay, I have found the same problem
with 3 KDS over the years. The coil in the relay runs hot and corrupts the
solder.
Check the whole board wile your at it.

-Joe

"Hank" wrote in message
...

I have a KDS VS-7P monitor that was purchased 18 months ago, but I just
started using it. Warranty has expired and shipping to KDS for repair
is way to expensive. Description of problem: Power led comes on. But
the relay does not engage. There is filament. If I unplug the
degaussing coil relay clicks in, but still no high-voltage. Can anyone
tell me what voltages should be coming from the power supply? What
should be the voltages on the flyback? Any known issues with the model
that may be cause a problem similiar to what I have described?


--
Hank