On Sun, 9 Jan 2005 22:26:42 -0600, "Dan Klima"
wrote:

Hello all!

I obtained a couple of nice maple burl pieces a while back that were
"dunked" in Anchorseal. Its really thick all over. There are pieces that I
would like to keep the natural edge on, but I'm not sure how best to remove
the Anchorseal from that part of the burl without damaging it. Are there
any solvents that could be used or am I destined to trying to pick it out
with dental tools?

Dan,

Are you sure it's Anchorseal? Usually when you get wood that has a
really thick coating on it like that, it's just plain old paraffin
wax. My wood guy gets all his exotics in like that and has to re-coat
them with Anchorseal because wherever the wax gets scraped off the
wood will check. If it's just paraffin, you might be able to remove
it with naptha, or the PRUDENT application of heat, from an indirect
source, like a Quartz Halogen lightbulb, hair dryer or heat gun. You
won't get it all, because some will penetrate the wood when it melts,
but it will be better than the thick layer.


--
Chuck *#:^)
chaz3913(AT)yahoo(DOT)com
Anti-spam sig: please remove "NO SPAM" from e-mail address to reply.


September 11, 2001 - Never Forget


----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 100,000 Newsgroups
---= East/West-Coast Server Farms - Total Privacy via Encryption =---