"N:dlzc D:aol T:com (dlzc)" N: dlzc1 D:cox wrote in
message news:rZWDd.23751$CH5.11854@fed1read01...
| Dear alanh_27:
|
| wrote in message
| ups.com...
| what is a fender washer? in which situation is it used?
|
| Just to add a little to John Kunkel's response...
| They also help distribute loading, when the bolted joint is into/includes
| sheet metal. Serves to stiffen up the bolted area.
|
| David A. Smith

Sort of. Usually not very strong, so they tend to sink a lot if you
torque them down to a reasonable amount. I've brazed a smaller washer on
top of a fender washer to stiffen one up, just stacking them only goes so
far. Actually, I needed it to remove and replace some bearings from the
front axle of my 4x4 truck. Had a 5/8" allthread going the length of the
axle and you couldn't get washers the right diameter with a 5/8" hole in it.
Lots of wrenching going on that day!