writes:

My washer is leaking from the tub, i think its overfilling, from a
prior repair i lost the schematic. So what controlls the amount of
water that fills up the tub? I know some switch must control the
inlet selinoid?

There's probably a pressure switch on a tube from the tube somewhere.

Basically, the controller enters a state where it's waiting for the water
to fill based on a set of contacts on that pressure switch.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.