I had a "runner" I gripped in the fence slot, after removing the RAS fence.
That way I had full distance to the right, where the existing fence, if left
in place would have interfered, and the full benefit of my tuning for square
to fence and heel out.

However, as indicated, went back to tilted blade.

"Bob G." wrote in message
...
On Tue, 28 Dec 2004 08:37:06 -0500, "George" george@least wrote:

Use the same one you use on the tablesaw, less the runners.

It's just split fences at angle. I always tilted my blade, though.

Thats just about right.... just a simple hunk of plywood with split
adjustable fences... IT IS NOT the same one I use on the tablesaw
but is identical except it has no runners and attaches to the RAS
table with a couple of bolts...

Bob Griffiths