Correct, the whole PCB is available as a replacment part but you must have
the complete Model Number including the XYL1 subscrip or the complete CTC
number. Also pay some attention to L14401?? in the Base circduit of the
Horiz output, also known to cause a lot of problems. The PCC boards have
been having problems with poor solder on the coils and active devices and
with caps around the small ic going leaky causing the thing to go nuts.
"RonKZ650" wrote in message
...
Can Anybody tell me what q14802 is responsible for in this set (it is on
a
seperate board attached to a heat sink on the main board)

It's one of the pincushion drivers. If bad it may cause width problems or
bowing in on the edges of the screen. Your chassis is a CTC203.