"Jerry G." bravely wrote to "All" (23 Nov 04 07:31:14)
--- on the heady topic of " 35"mitsubishi still have color problem"

How about the colour killer reference threshold?


JG From: "Jerry G."

JG Obviously there is some component that is just off value enough to
JG cause this fault. This can be very tough to find. Did you check that
JG the free-running frequency of the 3.58 mHz reference is close enough?
JG Especially that you changed the crystal, it may be too far out, since
JG these do have some tolerance in their specs. There should be an
JG adjustment that is done by either a trimmer cap on the circuit board,
JG or a software set-up of some type through a service menu, or a PC
JG interface.
JG --

JG Jerry G.
JG =3d=3d=3d=3d=3d=3d


JG "458" wrote in message
JG lkaboutelectronicequi
JG pment.com... have 35"mitsubishi with no color when cold. if you heat
JG up around the ic 201 0r caps along side of it color comes on froze
JG cap c-216 color came on. changed cap and does same thing with new as
JG old.esr all caps and they pin the needle. changed ic201, 358 crystal.
JG even had another complete pip cir board. and its the same with both.
JG it seems no matter what you freeze in that area color goes out. heat
JG it up and color comes back. could we be just changing the freq. of
JG something just enough to start color osc. any ideas? thanks jack@
JG allen park tv allen park mi.

.... Well I defragged my TV and went all the way back to basic cable!