In article ,
Andrew Mawson wrote:
Well it's the usual story - it's not the actual job that takes the times
it's the setting up and clearing up afterwards. Actually doing the job -
probably 4 per hour - say £7.50 plus postage if enough people respond.
Note this is ONLY to make the adaptor - 14mm female to 3/8" UNF female -
you need your own chuck with a 3/8" unf male stud, and an angle grinder
with a 14mm stud (they mostly are) and the use you put it to is ENTIRELY
at your own risk.

There's inflation for you. ;-) Put me down for one, though.

--
*Does fuzzy logic tickle? *

Dave Plowman London SW 12
RIP Acorn