On Mon, 15 Nov 2004 08:28:05 -0000, "IMM" wrote:


"Andy Hall" wrote in message
.. .
On Mon, 15 Nov 2004 01:05:12 -0000, "IMM" wrote:


"Andy Hall" wrote in message
.. .
On Mon, 15 Nov 2004 00:09:11 +0000 (GMT), "Dave Plowman (News)"
wrote:

In article ,
Shockwave wrote:
how about taxing copper pipework?

****s like u who r too stupid to use 'speedfit' would be taxed;
those
that can read instructions and use a piper cutter would be exempt.

Oi. Copper is not only cheaper, but makes a neater job. It requires
some
skill, but this is part of the fun.


You even have the opportunity to buy a pipecutter.

I think this Shockwave pillock works for Speedfit.

Well I don't know. When I think of 'pillock' and 'Speedfit' in the
same sentence, I am inevitably reminded of your hacksaw escapade.

Reminder: faulty fitting experience. Pipe cut brilliantly square. And you
put lots of Speeddfit in. Be afraid.

I've used quite a bit of lots of makes over the years, have followed
the instructions, used the right tools and never had any problems.



--

..andy

To email, substitute .nospam with .gl