a lot of these bits show up on E-bay, or in the larger machinery surplus
stores. Also a good way to get a jacobs chuck (be sure to get a ballbearing
chuck)
"Lobby Dosser" wrote in message
news:mWggd.5352$jD4.4729@trnddc06...
"Leo Lichtman" wrote:


"Lobby Dosser" wrote: Jacobs Chuck. Search on 'jacobs chuck' at
www.woodcraft.com (clip)
^^^^^^^^^^^^^
That's probably the best answer, but there are two other ways you can
go. Knowing the Morse taper number for yo9ur tailstock, you can get
drill bits with that taper on the shank. The main advantage is that
they use up less of the space between the spindle and tailstock, which
could matter if you are drilling into the end of a long spindle. It
is also possible to buy collets with a Morse taper to fit your lathe,
on the outside, and a bore to fit a certain drill diameter on the
inside. This has the advantage that you can use a drillset you
already have.




What do you call the bits with the MT shank and where might we find them?
I
can see that using such bits would be advantageous if you had a lot of
same
size drilling to do. Also less margin for error.