On Fri, 22 Oct 2004 01:15:45 -0400, "techdrive"
wrote:

Hi Again, We had another CTC203AX with a Bad Pip board that caused it too:
(F2PIP board) Try pulling the pip board out and turn the set on. It if
comes on the pip board is defective. -Mike

Mike, Same kind of several possible causes. Rather than just comdemn
it as defective, look at your F2PIP board, The LM317 regulator, on
solder side, there is two SMD resistors that trims the LM317
regulator's voltage output. One of two resistors has cracked solder.
Resolder that, and you should be good to go.

Done three of those.

Cheers,

Wizard