"Bob" wrote in message
...
In uk.d-i-y, Michael Brewer wrote:

1) You and others have mentioned that the regs say that the
control
switch for an appliance must be within 2m of that appliance. Do
the
regs say whether the control switch must be above the counter
(i.e.
instantly accessible) or is it OK to have them out of sight under
the
counter, but still accessible through a cupboard?


I would say the switches are for isolation rather than emergency use.

I have used 'hidden' switching throughout my wife's new kitchen,
mainly
because I used 'very hard' porcelain tiles that were a right pig to
cut
without stress cracking. I resorted to a diamond blade in my angle
grinder
in the end, but that's another story.

Hope that sheds some light on it,

Bob


A good point. There is a gas control valve near(ish) to where our gas
hob will be, but I'm going to put a socking great pan drawer unit in
front which will conceal it nicely to render it useless in case of an
emergency. Well, the drawers will of course be removeable, so I'm
hoping it's not going to offend against some gas regulation (I'm also
hoping I won't have to put a big sticker on the front of the drawer to
comply).

By the way, did you "hide" your switching at the back of a nearby
base/wall cabinet so as still to be reasonably accessible even if not
instantly visible?

Mike

Hi Mike,

I used 'architrave' switches for the lighting whihc fitted neatly behind
the
light pelmet under the wall units. All you have to do is know where they
are!

For the appliances, I fitted surface backing boxes to the top of the
backing
boards in the floor units with plugs and sockets, so if I need to carry
out
maintenance, there's no question of whether the electrics are isolated - I
just pull the plug! The exception to this is the dishwasher i left the
socket where it was, behind but to the side of the machine. However, it
is
accessible if I pull the kickboard off (fitted with clips) and stretch my
arm underneath. Not easy, but possible.

So long as having the control switches inside cupboards doesn't offend
against some regulation, I might well try that. Did you do this for your
cooker, too, or do you have a gas cooker?


The gas cocks are all accessible through cut-out in the back of the units,
again at high level so they're not obstructed in normal circumstances.

I think the best rule of thumb is to err on the side of caution and think
ahead 5 years to when you may need to carry out maintenance. having
fitted
a number of Kitchens over the years, my experiences have taught me what
not
to do!!!!

Thanks for the feedback!


HTH,

Bob