Is it possible to REMOVE hot melt glue from a motherboard?? I would like to
replace a Vartec barrel-type battery that was plunked into a blob of
something and then soldered to the board.
"Frithiof Andreas Jensen"
wrote in message . ..
"Orange" skrev i en meddelelse
...
Can high temperature of glue (170 to 200 C) damage PCB?
Hotmelt glue is poured liberally over many types of electronic circuit
boards in a production environment so, No - it's Ok.
Any tips for using hot glue?
Allow plenty of time for the glue gun to warm up - more than you think is
reasonable - otherwise the glue will not stick properly!
Place a newspaper under the glue gun - it will leak stick to the table
when
warm enough!
Whatever you glue must be clean & dry!
|