New to this group, but not to turning.
Two questions-- Anybody seen the MLCS routerbit that cuts 30-60 angles
for 6-12 piece stave blanks? Any good? They have two others for 8 & 16
pieces. $29.99 each. Couldn't you just set the jointer for 45 deg for
8 pcs & 22.5 deg for 16 pcs? Then cut off at 90 on the TS , crosscut
to stave height & glue up? Havn't tried it yet, but will follow this
thread & post when I do-- just wanted some feedback on the bits & the
alternate method. Have to fix the LM first
Phil