If its not a faulty brake, then if the rewind idler's not flicking across it
may cause the same symptom
Just looked at the manual (HR-DX22ek) which I think is the same machine
first remove the carriage (4 screws) then you can see an idler
clutch/geartrain between the 2 spools. remove the 2 screws
and you may find this is at fault. Its direct driven by gears through the
bigger dog clutch underneath. its shaft may be stiff (other models do have
this problem) or you can examine/clean re tension etc.make sure it can
flick/engage easily to both spools
If the main belt is slipping then it wouldn't rewind also.-
AW

"Bob Shuman" wrote in message
...
I fixed my Hitachi VCR that had similar symptoms about 2 years back. It
turned out to be a rewind "brake" that consisted of a small Mylar belt
that
had a small felt pad attached to it. The pad had started coming off the
Mylar. I was able to re-glue it and the unit functioned normally. Once
this
was determined to be the problem I ordered the replacement part from an
authorized Hitachi parts depot, but have never installed it since the
re-attached pad seems to be holding up well.

Good luck

Bob

"Reid Fleming" wrote in message
.. .

I have an old JVC JR-DX22U VHS deck that plays OK, but won't rewind
or eject without leaving a little bit of the tape (~6") out of the
cassette and chewing on it a little bit. Seems a shame to pitch
it, anybody know how I could fix this problem?

Please post as opposed to email. Thanks.