The program clock had a circuit diagram next to it with 60 settings detailed
inluding a pretty good description of each of the clock settings. THe
machine operates normally but as soon as the clock advances to a heating
setting (no. 12 on the dial) then the machine just continues cycling with no
heating. However if I manually advance the program to no 13. the machines
functions ok until the next heating phase and just hangs there. In other
words it fills with water and drains fine but at a heating stage it just
hangs. Any clues????

thanks for your interest

pmcdw

"Terry" wrote in message
...

"EricP" wrote in message
...
On 3 Sep 2004 09:38:55 -0700, (pmcdw)
wrote:

Hi,

My built-in General Domestic Appliances dishwasher (model BF50 B/W)
gets stuck on the heating phase of the program without the water
heating up. If I manually move the program forward then it seems to
work. So is it as obvious a problem as the heater. If so, what do I
need to do to repair including how do I gain access to the heater and
what would be the likely cost? Any help is appreciated.

cheers

pmcdw

Does it have a clock type programme dial like a washing machine?
ie a knob that goes around clicking each part of the programme on and
that you set the programme up with?

If so, the thing seems to be sticking and you could have a look at it
and see if the cams are working properly.

Just an idea.


Not familiar with the product but suggest;
If the timer, itself, switches on the water heater it might be that those
timer contacts carrying a fairly heavy current to the heater have become
defective? Then, depending on the circuitry some machines will not proceed
any further through their washing cycle until the water has reached, or is
at, a set temperature. So the thing acts like "No water" or "water too
cool"
and just stops and sits there? Depends on the logic and circuitry of the
machine. The heater itself may be OK, but electricity not reaching it for
some reason?
If however the timer just stops or jams at that point in the cycle and by
moving it manually water heats and everything else works OK, it may be a
timer problem. See if there is a circuit inside which may include a
diagram
of which cam on the timer controls each function. There may likely be a
set
of cam contacts that allow the timer to run until it is at end of cycle
and
then stop itself. If these contacts were dirty/corroded or the timer cams
worn the timer might stop rotating at that point? Most timers are
basically
driven by a little electric clock motor?
Recently we had a "no fill" dish washer problem and it was due to corroded
contacts of the timer switch itself and also to a defective/intermittent
microswitch float switch. The very simple logic of ours meant that the
machine does not check whether the water has gone in or not and it just
carried (dumbly) on through the whole cycle without any water at all! I
have
thought about modifying it, although since we've had virtually no problems
for about 20 years it probably isn't worth while!