Pecanfan wrote:

2. Is it possible to cut RSJs?

I had need to cut through two 200x8mm flitch plates. The first before it
was installed, did that with a 9" angle grinder - easy enough. The
second needed a short section trimmed flush to a surface after it was
installed. I used an Axminster reciprocating saw with a long hacksaw
blade on it. Also easy enough probably took a little longer but gave a
more precise cut.


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/