I put the screw through the end of the cap and into the end grain of the
handle. It is still holding.

--
Alan Bierbaum

Web Site: http://www.calanb.com
Current project: http://home.comcast.net/~cabierbaum/

"Nick Bozovich" wrote in message
news:qHbXc.11127$%11.2883@trnddc02...
Here's a stupid newbie question -

I'm making a "traditional" European workbench. It has a "dog leg" type
shoulder vice. I bought the vice screw from Lee Valley, along with the
wooden handles.

The wooden handles came with two end caps, and two screws. The end caps
fit
loosely, so, duh, I figured that the screws are meant to hold them onto
the
handle (I AM learning something!!). After much thought and consideration,
I
decided that I didn't want to use glue on the caps, otherwise I won't ever
be able to take them off.

So, when I attach the end caps with the screws, should I drill into the
"top" of the end cap and into the end grain of the handle, or into the
side
of the end cap and handle?

Seems like a small problem - I've been doing a LOT of learning as I build
this bench - some of it by trial and error, and some by reading and
research. I'm so close to being done, I'd like it to go smoothly without
another mistake.

Thanks in advance for your advice!


Nick B