On Wed, 25 Aug 2004 14:51:45 GMT, fred wrote:

In article , Set Square
writes
In an earlier contribution to this discussion,
Kalico wrote:

[snip]

something like this ?
http://www.screwfix.com/app/sfd/cat/...18649&ts=48872

Indeed

I looked at some of those in one of the sheds. They would do at a push, but
are really too large in diameter relative to the central hole - pushing the
hole in the worktop too far out from the corner. I reaaly want a smaller
flange than this.

How about a pipe stiffener for mdpe in white nylon as is has the through
hole sleeving and a small diameter flange to finish the top surface. I've got
one for 25mm here which is a bit too small (20o/d, 17i/d), but one for
32mm pipe would prob do the job (guess 27o/d, 24i/d?). Plumbers'
merchant will prob have one offs. Doesn't meet your chrome finish spec,
but you could place a bright plated or stainless washer under the flange.
I've tried it here & it looks ok but is actually less obtrusive without the
washer. Or do some mfrs make their stiffeners in Ali?

Hope you can visualise the idea.

On that idea, why not shine up one of the inserts for Hep2O?
Rob

Replace 'spam' with 'org' to reply